IRD-2600 / IRD-2800
Integrated Receiver Decoders
P/N 2349-72784-00 Page 1-9
1.2.2. Basic Configuration
The IRD-2600 and IRD-2800 are delivered in a wide range of standard configurations, as
described in paragraph 1.2.3 ahead. Paragraph 1.2.4 describes the add-on options available
for the various configurations.
However, all IRD-2600 / IRD-2800 configurations provide the following basic features:
• Profile: 4:2:0 (4:2:2 for IRD-2800 only)
• 2 slots DVB-CI Common Interface
• Video formats: PAL B/G/M/N/D, NTSC, SECAM L/B/G/K1
• Transcoding of 625/50 video formats (PAL B/G to/from PAL N and SECAM) and of
525/60 video formats (PAL M to/from NTSC)
• Two Composite outputs; One S-VHS output
• Full DVB compliance, as well as special modes for interoperability with certain non-DVB
IRDs
• Audio (1st channel): one stereo pair, balanced output via XLR connectors; volume
adjustment.
• Data channel: High-Speed Data @ RS-422 and Low-Speed Data @ RS-232
• DVB descrambling, SimulCrypt Support, Scopus CAS-5000 descrambling, BISS
DSNG-CA
• Over the air remote control; Over the air software upgrade
• Teletext, VBI (WSS, Close Caption, VPS, VITS, VITC, SMC), analog, over composite
• Selectable Audio/Video/Data combination mode OR Video-only OR Data-only OR
Audio-only mode.
• Monitor and Control via RS-232 or RS-485 terminal (factory pre-set).
• Auto-save of last configuration after power off; 140 pre-programmed setups (optional:
340).
• Front panel control; Extensive Status indicators; Signal quality (Eb/N0), Video/Audio rate,
CA information.
• RS-422 transport stream input
To Next Page
Loading...
