Seca ct330 - Configuring a Training Device for Stress ECG

38
3 Software
3
Instructions for Use
Resting & Stress ECG with seca
ct330/331 and seca diagnostic 5.9
3.2.4 Configuring a training device for stress ECG
→ In seca diagnostic, open the screen Examination, Stress ECG,
Settings, Device , Training device .
→ Select the previously set Ergometer or Treadmill .
→ Select the blood pressure module of the ergometer, the previously
connected and set blood pressure monitor or the Manual option.
→ Select the SPO2 module of the ergometer, the previously connected
and set SPO2 meter or the Manual option.
→ Click on Save to apply your input.
→ Close the screen with End .
→ The training device is ready for operation.
Fig. 13: Configure training devices
1
2
3
4
5
6
7
8
1
2
3
4
5
5
6
6
7
8