Seca ct330 - Seca Ct330;331 Connection to the PC; Setting up Seca Ct330 (USB)

33
3 Software
3
Instructions for Use
Resting & Stress ECG with seca
ct330/331 and seca diagnostic 5.9
3.2 seca ct330/331 connection to the PC
IMPORTANT:
Prerequisite - seca diagnostic is installed on your PC and
ready for operation. The seca devices and components may only be
connected to the PC after seca diagnostic has been installed. The
required device drivers are installed on the PC via the seca diag
nostic
standard setup or by specific selection during the seca diagnostic setup.
3.2.1 Setting up seca ct330 (USB)
Connect the ECG device to the PC using the supplied USB cable.
Power is supplied via the USB cable. This charges devices with an
integrated battery. The Windows driver installation starts automatically.
After the driver installation has been completed, the device is configured
in seca diagnostic.