A01350693 Rev:P ECO: 7476 Date: 04/14/08 12
As with any Wandering Monitoring System, each application can be different. Use the guidelines below as a basic understanding of
what a standard application would be like.
• Identify all the equipment that is to be installed. Inspect for any damage that may have resulted during shipment. If
damage is found, notify the shipping carrier immediately and arrange for an inspection. Be sure to retain all shipping
and packing materials.
• Install all communication wires from each exit system to the remote system annunciator location.
• Determine the location of the Exit Control Panel, making sure to accommodate for any local, state, or federal codes
or guidelines including ADA requirements, and mount as required. Standard applications would place this
equipment on the wall at the center of the door height on the latch side.
• Mount the Electromagnetic Lock in strict accordance with the manufacturer installation instructions. Be sure to
comply with all Life Safety and Electrical Codes as required.
• Mount the Magnetic Door Contacts provided with the Exit Kit on the latch side of the door. These contacts provide
a method of monitoring the open or closed status of the door.
• Route all necessary peripheral connection wires into the Exit Control Panel mounting box. These would include wires
such as communication, magnetic contacts, exit power, magnetic lock power, etc.
• Prepare all wires and make connections to the exit system. Special care should be taken to prevent loose connections
and shorts.
• Proceed to the remote system annunciator location to mount as required. This device should be easily visible by staff
for monitoring of the system. Common locations are centralized nurse stations or staffed reception areas.
• Make all necessary wiring connections as shown on the following pages.
• Plug in all power supplies and batteries. The system is now ready for testing.
SECTION 4 TYPICAL SYSTEM INSTALLATION
To Next Page
Loading...