A01350693 Rev:P ECO: 7476 Date: 04/14/08 40
Loiter Alarm
This feature, when programmed and enabled, allows the 135DE Exit Panel to create a unique audible alarm to report that a
transmitter is in the proximity of a monitored door for too long. If the transmitter were to leave the monitored area after the alarm
sounds, the alarm would reset automatically without staff intervention.
Loiter Alarm Factory Default Disabled
To change the time of the loiter alarm feature in seconds follow the three listed steps without pausing for greater than one second
between keystrokes.
1. Enter *567 or currently programmed secondary code
2. Enter *9876543218#XXX (where “XXX” = time in seconds; example -30 sec. = “030”, 3 min. = “180”)
3. Two confirmation beeps = change accepted
4. One confirmation beep = change not accepted
To enable the loiter alarm feature follow the three listed steps without pausing for greater than one second between keystrokes.
1. Enter *567 or currently programmed secondary code
2. Enter *9876543218#999
3. Four confirmation beeps = change accepted
To disable the loiter alarm feature follow the three listed steps without pausing for greater than one second between keystrokes.
1. Enter *567 or currently programmed secondary code
2. Enter *9876543218#909
3. Three confirmation beeps = change accepted
Advanced Security Mode
In Advanced Security Mode the Primary Reset Code (*234 or equivalent) and Tertiary Reset Code (*751 or equivalent) will
not allow the escort of a monitored resident. The Primary Reset Code may still be used to reset an alarm condition. If a
Push Button is used in Advanced Security Mode, it will not allow access while a monitored resident is within the detection
range. An audible alarm will sound while the Push Button is pressed and a monitored resident is nearby. In the absence of a
monitored resident the Push Button and Primary Reset Code will work as usual. Enabling the Advanced Security Mode
feature has no affect on the Secondary Reset Codes (*567 or equivalent) operation.
Advanced Security Mode
Factory Default Enabled
To enable the advanced security mode, follow the three listed steps without pausing for greater than one second between
keystrokes.
1. Enter *567 or Currently Programmed Secondary code
2. Enter *9876543215#999
3. Four confirmation beeps = change accepted
To disable the advanced security mode, follow the three listed steps without pausing for greater than one second between keystrokes.
1. Enter *567 or Currently Programmed Secondary code
2. Enter *9876543215#909
3. Three confirmation beeps = change accepted
SECTION 10 PROGRAMMING
To Next Page
Loading...