7. Debugging
SMF-MP10S User guide V1.1 Shanghai Seer Intelligent Technology Corporation 48
The specific operation is shown in the figure below:
The path for the forklift to enter the storage location is set to be one-way entry only, and
after picking and placing the cargo, it will drive out of the storage location along another
path. Here you need to adjust the sites according to the actual location. Note that the site
location and the path can overlap. The connection between the sites needs to be clearly
distinguished. Special attention must be paid when drawing to prevent dangerous accidents.
7.4.3.2 Without Recognition and Rich Site Space
When the forklift works in the mode without recognition but with rich site space, the forklift
may drive in and out the storage location in an arch path, as shown in the figure below:
To Next Page
Loading...