SEER SFL-MP10S - Charging of Robot; Storage of Battery

5. Battery and Charging
SMF-MP10S User guide V1.1 Shanghai Seer Intelligent Technology Corporation 24
5.3 Charging of Robot
The SMF-MP10S battery supplied along with the robot can be used for 4-5h, after which it
needs to be charged. Please use the original charger. The specific charging steps are as
follows:
1. Connect the charger to the manual charging interface and power outlet of the robot.
Note: The charging socket requires 10A of national standard and needs to be grounded.
2. It takes about 3h to complete charging.
Precautions for Charging
● To avoid rapid discharge and battery depletion, it is recommended to turn off the
robot when charging with a charger.
● If you use the same charger to charge two robots sequentially, please wait one
minute after the first robot is fully charged, and then charge the second robot to
ensure that the charger can correctly identify the second robot.
● Please use the original charger.
5.4 Storage of Battery
 The battery pack shall be stored at an ambient temperature of 0-40°C and a relative
humidity of 10%-90%RH.
 The battery pack shall not contact with corrosive substances or magnetic environment.
 The battery pack shall be stored in a clean, dry and ventilated environment, away from
fire or heat sources.
 When the battery pack is stored for a long time, it shall be charged and discharged once
a month.