9. Product Maintenance
SMF-MP10S User guide V1.1 Shanghai Seer Intelligent Technology Corporation 66
Anti-electrostatic Floor - Slight Traces
Floor cleaning requirements:
Inspect the floor every day, and clean the dust, foreign matter and liquid contaminant
timely for the purpose of preventing the robot sliding.
Clean up the traces of the universal wheel on the floor timely for the purpose of
avoiding serious traces.
9.4.2 Robot Cleaning
It is necessary to determine whether to clean the robot frequently according to the
environment and uses. If the running environment of the robot is harsh, such as with sea
water, chemicals, waste, and cement, it must be thoroughly cleaned. Air compressors, and
detergents etc. can be used for cleaning.
Precautions for Robot Cleaning
● Never rinse the robot directly with water.
● Do not clean the robot with thinner, or gasoline etc.; otherwise, it will damage the
electronic and plastic parts of the robot.
1. Before assembling the body, use an air gun to clean the dust and sundries in the body,
and inspect the body after cleaning; there shall be no defects such as residues and dirt on it.
2. After assemble the body (without the shell), inspect whether there are any residues such
as screws, cut copper wires, or wire leather etc. in the body. If found, it must be cleaned up.
No residues shall be left over in the body.
3. Inspect whether the wiring in the body is neat, and there shall be no dust or dirt on the
wires. If found, wipe it with alcohol.
4. Install the shell and wipe it with a dry cloth.
5. If the dry cloth is still dirty after cleaning, dip a little alcohol to clean the surface until it is
completely clean.
To Next Page
Loading...