SEER SFL-MP10S - Load Safety; Parking Safety

2. Safety
SMF-MP10S User guide V1.1 Shanghai Seer Intelligent Technology Corporation 4
 Whether the load handling device is damaged (such as bent, cracked or worn).
 Whether the warning device is normal.
 Whether the ambient light is normal.
 Whether the function of the laser sensor is normal.
 Whether the battery level is normal.
 Whether the charging function is normal.
2.3.2.3 Running on Ramp
 Only run on the ramp meeting the performance parameters. Please refer to 3.7
Passability.
 The upper and lower ends of the ramp shall be flat to prevent the load or robot from
touching the ground.
 It is prohibited to turn around, run diagonally or stop on the ramp.
 When the tractor is towing a trailer without a brake, the emergency braking shall not be
applied.
2.3.2.4 Running in Elevator or Lifter
 Ensure that the elevator or lifter can bear the full weight of the robot and its load.
 Ensure that no part of the robot is in contact with the car wall of the elevator or lifter.
 Ensure that the robot would not move unexpectedly.
 Ensure that the elevator meets the standard GB 7588-2003.
2.3.3 Load Safety
 SMF-MP10S and its load shall not exceed the allowable range of the road surface.
 The load carried must be reliably secured.
 The load carried must be placed in the load center with certain anti-skid measures.
Please refer to 11. Load Center
.
 The weight of the load must be evenly distributed on two forks without partial load.
2.3.4 Parking Safety
 When the robot stops running, shut down and cut off the power supply.
 Do not park on the ramp.
 Do not park near heat sources or fire sources.
 Do not park in open pits, underground passages, elevator shafts or other similar areas.
 Do not park in the fire paths, stair openings and areas obstructing the passage of
firefighting equipment.