SEER SFL-MP10S - Software Functions; Network Requirements and Configuration

3. Product Introduction
SMF-MP10S User guide V1.1 Shanghai Seer Intelligent Technology Corporation 19
accuracy of the point, but not the fitting accuracy of the path. The minimum site spacing
supported by SMF-MP10S is 1cm. Therefore, the robot should not be used as a linear guide.
3. The actual running speed depends on the actual environment on site.
4. The basic functions include map editing, model editing, localization module, navigation
module, basic motion model (differential), peripheral expansion (roller, jacking, and latent
traction) supported, and API interface etc.
5. Need to be used with a dedicated automatic charging pile of SEER.
6. Need to be used with a special camera.
7. Need to be used with A 3D camera in the peripheral extension to realize this function.
8. SMF-MP10S is designed for indoor transportation only and is not recommended for
outdoor use.
3.8 Software Functions
 Map editing
 Model editing
 Localization module
 Navigation module
 Peripheral expansion
 API interface
 Visible operation
 Multi-robot dispatching
 Wi-Fi roaming
 Automatic charging
 Laser reflector navigation
 3D obstacle avoidance
 Pallet recognition
3.9 Network Requirements and Configuration
Network Requirements
Wireless network protocol: IEEE 802.11 a/b/g/n
Broadband speed: ≥100Mbits
Signal intensity: ≥-60dBm
Network delay: Average delay time ≤100ms
Network Configuration
Please refer to Network Configuration Guide for Robot for network configuration.