3.5. Shipping The Game Board
Replacement or repair of the Game Board (Chihiro) for this product should be undertaken
at the appropriate repair centre. Be sure to follow the specifications below when requesting
repairs/sending the board to the repair centre. Not following the specifications may result in
the board not being accepted or in extra charges being made.
•
Put the game board in the carton box as is. Do not carry out any disassembly or part
removal other than that specified.
• Follow the procedure and instructions regarding direction below when placing the
Game Board in the carton box.
•
When packing the game board with the Media Board attached, do not remove the Key
Chip.
• When packing the game board with the Media Board detached, be sure to include the
AVIP Cable.
•
When packing, attach the accessory stickers in the specified places on the Game
Board and carton box.
INSTRUCTIONS
1. Wrap the Chihiro Board in a plastic bag.
2. Place it on top of the bottom surface cushioning material. Turn the Filter Board to face the side
with the three honeycomb buffers. Packing it in the opposite direction may cause damage to the
Filter Board.
3. Insert corrugated cardboard into the space between the lateral honeycomb buffers of the bottom
surface cushioning material and stow the AVIP cable inside.
4. Place the Chihiro Board wrapped in the bottom surface cushioning material into the carton box.
Use the handles on the bottom surface cushioning material.
5. Place the upper surface cushioning material on top of the Chihiro Board. Be sure to align it in the
right direction, as it will not fit otherwise.
6. Close the top of the carton box and seal it tightly with adhesive tape.
To Next Page
Loading...
Need help?
General
