3.7.5. Assembly Check
In the Test Mode, ascertain that the assembly has been made correctly and IC BD is satisfactory (see
Section 5.3).
In the test mode perform the following test:
3.7.5.1. CRT Test
•
Only QUALIFIED SERVICE PERSONNEL should carry out this operation.
C.R.T TEST
PAGE 1/2
C.R.T. TEST 1/2
PRESS TEST BUTTON TO CONTINUE
RED
GREEN
BLUE
WHITE
In the TEST mode select CRT test to check the
screen is satisfactory.
Although the projector has been set up at the
factory before shipment, check to see if the screen
needs adjustment.
C.R.T. TEST 2/2
PRESS TEST BUTTON TO EXIT
To Next Page
Loading...
