3.8. Moving The Machine
•
When moving the machine, be sure to remove the plug from the power supply.
Moving the machine with the plug inserted can cause the power cord to be damaged,
resulting in a fire or electric shock.
•
When moving the machine, retract the leg adjusters fully and ensure the casters make
contact with the floor. During movement pay careful attention so that the casters or leg
adjusters do not damage any other cabling laid on the floor. Such damage could result
in a fire or electric shock.
• Do not push the upper part of the cabinet. Failure to observe this can cause the
cabinet to fall forwards and result in accidents.
• When transporting the machine, be sure to hold the catch portion on the rear of the
cabinet with the castors making contact with the surface as shown below. Inclining the
machine by holding portions other than the catch or moving the cabinet without
retracting the adjusters can damage the cabinet and/or the floor surface.
• Do not push the Billboard. Failure to observe this may damage the installation
portions and may cause unexpected accidents.
• Only QUALIFIED SERVICE PERSONNEL should carry out this operation.
To Next Page
Loading...
Need help?
General
