25
www.seuservice.com
Attach the pedal to the foot base using 4 hexagonal bolts. Be sure not to tighten the hexagonal
bolts completely.
Pull wire from the pedal to the foot base and connect the connector on the end of the wire to the
connector on the U-shaped bracket. Use the cord clamp in the foot base to secure the wire.
PHOTO 6. 3 g
Connect the connector.
CORD CLAMP
PEDAL
Remove the 2 screws and remove
the plate sash from the pedal.
PLATE SASH
PHOTO 6. 3 h
Insert the fence into the pedal and
attach with 4 hexagonal bolts. Use
the large at washers with the hex-
agonal bolts used on the cabinet.
PHOTO 6. 3 i
FENCE
HEXAGONAL BOLT (4)
M6×16, w/spring washer,
at washer used
SCREW (2), black
M4×8, w/at & spring washer
HEXAGONAL BOLT (2), black
M8×16, w/spring washer, at washer used
To Next Page
Loading...
