Sega VIRTUA COP - Page 76

68
www.seuservice.com
69
www.seuservice.com
FIG. 9. 3 d GUN ADJUSTMENT screen

  

���������������GUN�ADJUSTMENT
�����PLAYER�1���������������PLAYER�2
->�TOP�������5��233����->�TOP�������5��233
���LEFT���-318���17�������LEFT���-318���17
���CENTER��-10���15�������CENTER��-10���15
���RIGHT���242���34�������RIGHT���242���34
���BOTTOM��-10�-204�������BOTTOM��-10�-204
���DEFAULT����������������DEFAULT
���CANCEL�����������������CANCEL
���CURSOR�����������������CURSOR
���������SELECT�WITH�SERVICE�BUTTON
��������������AND�PULL�TRIGGER
���������PRESS�TEST�BUTTON�TO�EXIT
D. GUN ADJUSTMENT
Select GUN ADJUSTMENT to display the following screen.
This screen allows you to adjust the gun using the ve calibration targets (TOP, LEFT,
CENTER, RIGHT, BOTTOM). Use each target to calibrate as follows.
Use the standard gun controller, carefully aim at the correct target and pull the trigger to
calibrate the value. Select between the calibration targets with the 1P and 2P START buttons or
SERVICE button.
Details for each item are as follows.
 TOP x y: Set the TOP value.
The number on the left (x) is the horizontal component, and the
number on the right (y) is the vertical component. Aim the controller
at the TOP target (circle) and pull the trigger to set the value. This will
not affect horizontal calibration.
 LEFT x y: Set the LEFT value.
The number on the left (x) is the horizontal component, and the
number on the right (y) is the vertical component. Aim the controller
at the LEFT target and pull the trigger to set the value. This will not
affect vertical calibration.
 CENTER x y: Set the CENTER value.
The number on the left (x) is the horizontal component, and the
number on the right (y) is the vertical component. Aim the controller
at the CENTER target and pull the trigger to set the CENTER value.
 RIGHT x y: Set the RIGHT value.
The number on the left (x) is the horizontal component, and the
number on the right (y) is the vertical component. Aim the controller
at the RIGHT target and pull the trigger to set the RIGHT value. This
will not affect vertical calibration.