77
www.seuservice.com
Remove the soldering and extract the microswitch.
Solder a new microswitch and rebuild the gun controller. Make sure that the wire in the right
shell (Cover R) and the connector are wired as in the diagram before reattaching the left shell
(Cover L) to the right shell. Also, be careful not to overtighten the screws.
Test the trigger and the weapon change button to make sure that the microswitch switches ON
and OFF properly.
COVER L
MICROSWITCH
509-5080
WEAPON
CHANGE BUTTON
SPRING
SCREW (1)
M3×8, w/flat & spring washer
SWITCH BRACKET
SCREW (2)
M2.3×10, w/flat & spring washers
SENSOR UNIT
JPT-2030
Disconnect the connector.
COVER R
SCREW (10), black
M3×10, w/small flat
& spring washers
FIG. 10
To Next Page
Loading...
