EasyManuals Logo

Sencore OmniHub 6 User Manual

Sencore OmniHub 6
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
OmniHub 6/6D– User Manual
Page 59 of 182
AAC Format
ADTS, LATM
Service
Parameter
Range
Service Parameter
Range
Program Name
String between 1~31
Audio PID
32~8190
Provider Name
String between 0~31
PCR PID
32~8190
Video PID
32~8190
PMT PID
32~8190
The OHE6-HDMI-02C module supports two sets of audio and video input in total. Each
set includes 1 HDMI port/1 component portand1 analog port.
If the video comes from HDMI, there are three options for encoding dual audio:
1. One audiocomes from HDMI and the other comes from analog; the encoding
format can be the same or different.
2. Dual audio all come from HDMI with the same content and the encoding format
can be the same or different.
3. Dual audio all come from the analog input with the same content and the
encoding format can be the same or different.
If the video comes from the component, there is only one choicefor encoding dual
audio:
Dual audio all come from the analog input with the same content and the
encoding format can be the same or different.
3.4.4.3 IP Output
This feature is specifically for encoding a single program and outputting it directly to IP. It
will not occupy multicast bandwidth of the baseboard.
If you want to use IP output channel on the encoder module and the baseboard IP
module at same time, you should avoid the multicast IP addresses conflicts. If there are
two same IP addresses enabled meantime, all the multicast videos will be affected.
Destination IP Address and Destination Port: for multicast IP addresses or
unicast IP addresses and ports.
Enable Destination MAC: Generally, you do not need to enable this option. This
is reserved for exceptional cases when the unicast stream cannot be received
using unicast IP addresses. You can enable destination MAC and streaming out
by setting Destination MAC.
To use Multiplexing mode on service level:
1. Click on (pencil) icon. There will always be a BaseBoard selection for the IP
output and other Output options depending on the module inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check Multiplex on the channel you want to outputt. You can output multiple
services to one channel or output one service to multiple channels.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sencore OmniHub 6 and is the answer not in the manual?

Sencore OmniHub 6 Specifications

General IconGeneral
BrandSencore
ModelOmniHub 6
CategoryMedia Converter
LanguageEnglish

Related product manuals