OmniHub 6/6D– User Manual
Page 35 of 182
To clear the whole routing table click button.
There is a channel scan button on top. Normally
the input service list of each channel will lshow on this page, but when you change the
input source, you should refresh the changed channels manually by selecting the
channel and clicking Channel Scan button.
3.3.1.5 Module System Operation
In System Operation tab, you can choose the modulation type as DVBC Mode or
DTMB Mode. Here you can also perform the following tasks:
Import / Export License
Log Manage
Reboot
Factory Default the unit
3.3.2 OHR6-DVBC-ISDBT-01
OHR6-DVBC-ISDBT-01 is a 4-channel DVBC Annex B/ISDBT receiving and
descrambling module with 1 RF female connector and 2 CI slots. The module can
receive signals via 4 RF channels simultaneously and support 2 CAM cards for
descrambling. Configuration of the module is very much similar to that of OHR6-DVBC-
00. For configuration of this module, please refer to page 30 to 35.
To Next Page
Loading...
