OmniHub 6/6D– User Manual
Page 34 of 182
To use Bypass or Multiplexing mode on stream level:
1. Click on the (cog) icon . There were always have BaseBoard selection for the
IP output and other Output options depending on the modules inserted.
2. Select the correct Output and Channel you want to output the stream to.
3. Check Multiplex or Bypass on the Channel you want to output
4. Click the Apply button on the right side to make the change takes effect.
To use Multiplexing mode on service level:
1. Click on (pencil) icon. There will be always a BaseBoard selection for the IP
output and other Output options depending on the modules inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check on Multiplex on the channel you want to output. You can output multiple
service in one channel or output one service to multiple channels
4. Click the Apply button on the right side to make the change takes effect.