Sencore OmniHub 6 - Page 76

OmniHub 6/6D– User Manual
Page 76 of 182
Audio Source
SDI1
SDI2
SDI3
SDI4
Analog
Volume (dB)
-20~20
AAC Format
ADTS, LATM
Service
Parameter
Range
Service Parameter
Range
Program Name
String between 1~31
Audio PID
32~8190
Provider Name
String between 0~31
PCR PID
32~8190
3.4.5.3 IP Output
This feature is specifically for encoding single program and outputting directly to IP. It will
not occupy multicast bandwidth of the baseboard.
If you want to use IP output channel on the encoder module and the baseboard IP
module at same time, you should avoid the multicast IP addresses conflicts. If there are
two same IP addresses enabled meantime, all the multicast videos will be affected.
 Destination IP Address and Destination Port: for multicast IP addresses or
unicast IP addresses and ports.
 Enable Destination MAC: Generally, you do not need to enable this option. This
is reserved for exceptional cases when the unicast stream cannot be received by
with the unicast IP addresses. You can enable destination MAC and streaming
out by setting Destination MAC.
The second eth is reserved to output IP streams in an another different VLAN. Enabling
the second eth and set IP Address, Subnet Mask, Default Gateway in the same
segment of the Unicast IP (the another different VLAN), you can output the Unicast
stream to the another VLAN.
To use Multiplexing mode on service level: