SL MCR DW
110
All LEDs are green
▷ After the power supply is switched on:
The device is starting (approx. 20 seconds). Afterwards the
status information is displayed.
All four LEDs light up green during startup even with the
two-channel variant SL MCR 2 DW.
▷ During operation:
A radio link to the transmitters has been established for all
channels.
All LEDs are flashing green
▷ The Identify function for the entire device was initiated in
the Control Cockpit.
All LEDs are yellow
▷ All received transmitters have been muted with the MUTE
switch.
All LEDs are flashing yellow
▷ The device is performing a firmware update.
See „Updating the firmware“.
All LEDs are red
▷ There is no radio link to a transmitter for any of the chan-
nels.
All LEDs are flashing red
▷ A device error has occurred. Details are shown in the Con-
trol Cockpit.
or
▷ An error occurred while updating the device firmware. De-
tails are shown in the Control Cockpit.
A channel's LED is green
▷ A radio link to the transmitter is established.
A channel's LED is flashing green
▷ The Identify function for this channel was initiated in the
Control Cockpit.
The LED of the received transmitter also flashes.
To Next Page
Loading...
