Sennheiser SpeechLine - Connecting the receiver

SL MCR DW
96
Connecting the receiver
The receiver can output analog and digital audio signals.
The analog audio signal is output via the 3-pin Analog Out ter-
minal.
Digital audio signals are output via the Dante interface with
two RJ-45 sockets. This interface is also used for control and
configuration via the network and for Power over Ethernet
supply.
The following variants are possible:
►
To configure the variants you need the Audinate Dan-
te Controller software: www.audinate.com
PoE /
network control
digital audio
PoE /
network control
digital audio digital audio
PoE /
network control
digital audio
Variant 1
Single Cable Mode (default)
Variant 2
Audio Redundancy Mode
Variant 3
Split Mode
daisy chain