Sequential Prophet VS - Page 102

102
Byte Description Range Examples/notes
Parameter Select LSB
BN N = channel number
62 LSB
pp parameter number (00-7F). (For parameter numbers, see Table 14-1.)
Transmit
If enabled, sent whenever a parameter is changed on the VS. Followed by
Parameter Select MSB message, and Data Entry bytes. If the parameter
adjusted on the VS is a switch bit (see Table 14-1), then Parameter Select
messages must be sent before Data Entry bytes. For continuous parameters
(levels, rates, etc.), Data Entry messages aect the last parameter selected.
Receive
Aects selected MIDI parameter in the current program only. Parameters must
rst be selected over MIDI (LSB followed by MSB) before Data Entry bytes can
be received (see below).
Parameter Select MSB
BN N = channel number
63 MSB
pp parameter number (00-01)
Follows Parameter Select LSB message.
Once the parameter has been selected over MIDI, only Data Entry messages
need be sent, unless the parameter selected is one of the switch bytes (see
Table 14-1), in which case the parameter bytes are always required before the
data bytes.
Data Entry LSB
BN N = channel number
26 Data entry LSB
pp parameter value (00-7F)
Always followed by Data Entry MSB message. See Parameter Select, above.
Data Entry MSB
BN N = Channel number
06 Data Entry MSB
pp parameter value (00-7F)
May be sent following, or without Data Entry LSB message.
HOME

BACK