Sequential Prophet VS - Page 103

103
Byte Description Range Examples/notes
Program Number
CN N = channel number 0-F
pp Program number (00-63), select cartridge (7E), or select internal (7F).
Transmit
In Mode 1, the channel number equals the RIGHT CHANNEL value. In Modes
3 or 4 program number for each side is sent on the appropriate base channel.
Transmitted with each front panel program select.
Receive
In Mode 1 channel number is ignored. Treated like front panel selection.
In Modes 3 or 4 and single keyboard mode, the channel number must equal
the RIGHT CHANNEL value.
In Modes 3 or 4 and Split or Double, if received on right channel, acts as
program select. If received in left channel, switches linked program only.
Channel Pressure
DN N = channel number 0-F
pp pressure value 00-7F
For transmit and receive, channel number treated same as MOD wheel.
Receive
In Modes 3 or 4 with Split or Double on, if the left and right channels are
dierent, pressure aects the current and linked programs separately.
Pitch Wheel Change
EN N = channel number 0-F
LS 00-7F
MS 0 0-7F MS LS (Most/Least Significant)
00 00 is full bend down
00 40 is centered wheel
7F 7F is full bend up
Examples are regardless of internal bend scaling.
Receive
Has no eect on arpeggiated notes. Channel number treated same as MOD
wheel.
Full 14-bit resolution. Accuracy depends on Pitch wheel range. If full 14 bits
not used, left-justify (to bit 6) remaining bits in LSByte.
HOME

BACK