viii
LIST OF TABLES
TABLE PAGE
Table 1.1 Transducer FSD values ............................... 1.12
Table 2.1 Rack mount installation kit parts list ..................... 2.5
Table 2.2 Loose socket parts ................................... 2.12
Table 2.3 Signal terminal location PL1 to PL4 ..................... 2.13
Table 2.4 Signal terminal location PL5 ........................... 2.14
Table 2.5 Serial output connections PL6.......................... 2.14
Table 2.6 External autocalibration connections .................... 2.15
Table 2.7 External autocalibration truth table...................... 2.15
Table 2.8 Sample ports ........................................ 2.16
Table 2.9 Sample gas conditions ................................ 2.20
Table 2.10 Recommended calibration gases ....................... 2.22
Table 2.11 Recommended component concentrations ............... 2.22
Table 3.1 Changing the passwords .............................. 3.1
Table 3.2 Setting time and date ................................. 3.2
Table 4.1 Recommended calibration periods ...................... 4.2
Table 4.2 Setting low and high calibration tolerances............... 4.3
Table 4.3 Paramagnetic low and high calibration................... 4.4
Table 4.4 Gfx sensor low and high calibration ..................... 4.6
Table 4.5 Low cal check ....................................... 4.8
Table 4.6 High cal check....................................... 4.8
Table 4.7 Setting up auto calibration and auto check ............... 4.13
Table 4.8 Initiating auto cal or check from keypad .................. 4.14
Table 4.9 Aborting auto cal or auto check......................... 4.15
Table 4.10 External analogue input scaling ........................ 4.16
Table 5.1 Setting up alarms .................................... 5.2
Table 5.2 Allocation of relays ................................... 5.4
Table 5.3 Clearing of relay assignment ........................... 5.5
Table 5.4 Analogue output span limits ........................... 5.6
Table 5.5 Setting up analogue outputs ........................... 5.7
Table 5.6 Clearing an analogue output assignment ................. 5.8
Table 5.7 Component name definition ............................ 5.9
Table 5.8 External analogue input definition ...................... 5.10
Table 5.9 Defining and selecting measurement displays ............ 5.11
Table 5.10 Setting response time and resolution.................... 5.12
Table 5.11 Setting the NO
x
conversion parameters .................. 5.14
Table 5.12 Serial communications parameters...................... 5.15
Table 5.13 Setting the serial output frame frequency ................ 5.16
Table 5.14 Setting the serial output communications parameters ...... 5.17
Table 6.1 Displaying alarms present ............................. 6.1
Table 6.2 Displaying faults present .............................. 6.1
Table 6.3 Displaying relay configuration.......................... 6.2
Table 6.4 Displaying analogue output configuration ................ 6.3
Table 6.5 Displaying alarm settings.............................. 6.4
Table 6.6 Displaying analyser identity............................ 6.5
To Next Page
Loading...
Need help?
General
