SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Electrical installation; Network security and access protection

2
Safety notes
Electrical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
11
2.8 Electrical installation
Ensure that all of the required covers are correctly attached after carrying out the elec-
trical installation.
Make sure that preventive measures and protection devices comply with the applic-
able regulations (e.g. EN60204-1 or EN61800-5-1).
2.8.1 Required preventive measure
Make sure that the product is correctly attached to the ground connection.
2.9 Network security and access protection
A bus system makes it possible to adapt electronic drive technology components to
the particulars of the machinery within wide limits. There is a risk that a change of pa-
rameters that cannot be detected externally may result in unexpected but not uncon-
trolled system behavior and may have a negative impact on operational safety, system
availability, or data security.
Ensure that unauthorized access is prevented, especially with respect to Ethernet-
based networked systems and engineering interfaces.
Use IT‑specific safety standards to increase access protection to the ports. For a port
overview, refer to the respective technical data of the device in use.
2.10 Short designation
The following short designations are used in this documentation.
Type designation Short designation
MOVI-C
®
CONTROLLER progressive UHX65A MOVI-C
®
CONTROLLER
28514688/EN – 02/2019