SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Procedure While Updating Firmware; Exporting a firmware image

8
Procedure while updating firmware
Exporting a firmware image
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
50
8 Procedure while updating firmware
Perform the steps described in the following chapters to update the firmware of the
MOVI-C
®
CONTROLLER.
8.1 Exporting a firmware image
1. Create a new project in MOVISUITE
®
via "Planning" in the "Start" menu.
2. In the function view of the MOVISUITE
®
project, add the required
MOVI-C
®
CONTROLLER in the required version.
3. Select the MOVI-C
®
CONTROLLER in the MOVISUITE
®
project.
ð The configuration menu of the MOVI‑C
®
CONTROLLER opens.
4. In the "Functions" section, open the "Data management" sub-menu and the "Ex-
port firmware" menu.
28127358475
5. Click the [Firmware export] button in the "Export firmware" menu.
ð A dialog opens where you can select the export directory.
6. Navigate to the export directory and confirm your selection by clicking [OK].
ð In the selected export directory, the firmware of the MOVI-C
®
CONTROLLER is
stored as zip-file (file name: FS.zip).
28514688/EN – 02/2019