SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Status LED 24 V; Status LED L1

4
Installation notes
Status LEDs
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
35
4.6.2 Status LED "24V"
Status Meaning Measure
Green The voltage supply of the
device is OK.
–
Off Device has no voltage supply. Check the voltage supply at
the respective terminal.
4.6.3 Status LED "L1"
Indicates the status of the firmware during the boot phase and during operation.
During boot phase
Status Meaning Measure
Orange, flashing
with 0.5Hz
Firmware of the device starts
properly.
–
During operation
Status Meaning Measure
Green, flashing with
0.5Hz
Firmware of the device is run-
ning properly.
–
Red, flashing with
0.5Hz
The firmware of the device is
faulty.
Contact SEW‑EURODRIVE
service.
4.6.4 Status LED "L2"
Indicates the status of the IEC program.
Status Meaning Measure
Off No IEC program loaded. Load an IEC program on the
device.
Orange, flashing
with 0.5Hz
Program has stopped running. Start the IEC program.
Red, flashing with
0.5Hz
The IEC program is faulty. Check and correct the IEC
program.
Green, flashing with
0.5Hz
IEC program is running cor-
rectly.
–
4.6.5 Status LED "L3"
Status Meaning Measure
– Reserved –
28514688/EN – 02/2019