SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Device Replacement; Device replacement

7
Device replacement
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
49
7 Device replacement
When replacing a MOVI‑C
®
 CONTROLLER, note the chapter "Installation
notes"(→218). Insert the OMH CFast memory card of the MOVI-C
®
CONTROLLER
to be exchanged into the new MOVI-C
®
CONTROLLER.
The variable values stored permanently on the MOVI-C
®
CONTROLLER are not
stored on the OMH CFast memory card by default. Select one of the following proced-
ures to store the variable values on the OMH CFast memory card:
• Program a corresponding IEC program.
• Load the data backup into the engineering software MOVISUITE
®
via the project
management (in preparation).
INFORMATION
For information on replacing the drives, refer to the manual of the corresponding ap-
plication inverter.
28514688/EN – 02/2019