SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Introduction; Content of this manual; Additional documentation

3
Introduction
General information
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
12
3 Introduction
3.1 General information
3.1.1 Content of this manual
This manual describes:
• The installation of the MOVI‑C
®
CONTROLLER
• The interfaces and LEDs of the MOVI-C
®
CONTROLLER
• The engineering access to the MOVI‑C
®
CONTROLLER
• Use of CFast memory cards
• The interfaces of the MOVI‑C
®
CONTROLLER used in connection with CFast
memory card
• The first boot process of the Windows operating system
3.1.2 Additional documentation
To be able to configure and startup the MOVI‑C
®
CONTROLLER simply and effect-
ively, you should also order the following documentation in addition to this manual:
• "Automation with MOVI-C
®
CONTROLLER" manual
• "MOVIDRIVE
®
modular application inverter" product manual
• "MOVIDRIVE
®
system application inverter" product manual
When using the CFast memory card with a Windows operating system:
• Observe the Microsoft documentation exclusively for the configuration and opera-
tion of the Windows operating system.
Always use the latest edition of documentation and software.
The SEW‑EURODRIVE website (www.sew‑eurodrive.com) provides a wide selection
of documents for download in various languages. If required, you can also order prin-
ted and bound copies of the documentation from SEW‑EURODRIVE.
28514688/EN – 02/2019