SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Installation Notes; Electrical installation; EtherCAT;SBusPLUS connection

4
Installation notes
Electrical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
27
Reading out the version number of the software package
You can view the version number of the software package installed on the "OMW
CFast memory card"(→217) via the Windows settings.
Proceed as follows:
1. Open the start menu and type "Control Panel" into the search field.
2. In the result list, click on the app entry [Control Panel].
3. Select the "System and Security" submenu and click on "System".
ð The "View basic information about your computer" window opens.
27826473227
ð The version number of the software package is displayed in the "Model" line in
the "System" section.
4.3.6 EtherCAT
®
/SBus
PLUS
connection
The MOVI-C
®
CONTROLLER serves as EtherCAT
®
/SBus
PLUS
master for the lower-
level application inverters (EtherCAT
®
/SBus
PLUS
slaves). The communication takes
place via the EtherCAT
®
-based, fast system bus SBus
PLUS
(X30).
EtherCAT
®
/SBus
PLUS
bus topology
EtherCAT
®
/SBus
PLUS
is designed for linear bus structure with RJ45 connectors. The
EtherCAT
®
/SBus
PLUS
slave devices are connected via a shielded twisted-pair cable.
INFORMATION
According to IEEE 802.3, 200 Edition, the maximum cable length for
10 MBaud/100 MBaud Ethernet (10BaseT/100BaseT) between 2 EtherCAT
®
/
SBus
PLUS
stations is 100m.
For an example of a EtherCAT
®
/SBus
PLUS
bus topology, refer to chapter Overview of
communication interfaces.
28514688/EN – 02/2019