SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Introduction; MOVI-C CONTROLLER

3
Introduction
MOVI-C® CONTROLLER
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
15
3.2.4 Overview of communication interfaces
MOVI‑C
®
CONTROLLER has the following communication interfaces:
• The Ethernet communication interfaces allow for engineering purposes for the
MOVI‑C
®
CONTROLLER, for connecting an operator panel as well as for commu-
nication with other Ethernet nodes (e.g. with a PLC).
• The EtherCAT
®
/SBus
PLUS
interface is used to control drive inverters, I/O modules
and other EtherCAT
®
slave components.
• The Windows operating system provides USB interfaces for connecting a mouse,
a keyboard, or a touchpad. A monitor can be connected via the DisplayPort inter-
face.
L1
24V
L2
L3
X90
X80
USB1
USB2
USB3
XM2
XM1
RUN ERR
X15
X21 X20 X31
S1
S2
+UZ
-UZ
X4
+UZ-UZ
24V
X5
+UZ
X4
-UZ
-UZ +UZ
GND
X31X20_1X21_1
X20_2X21_2
X15_1
X15_2
S1
S2
RUN ERR
+UZ
X4
X5
24V
GND
-UZ
+ UZ- UZ
X31X20_1X21_1
X20_2X21_2
X15_1
X15_2
S1
S2
RUN ERR
+UZ
X4
X5
24V
GND
-UZ
+ UZ- UZ
X31X20_1X21_1
X20_2X21_2
X15_1
X15_2
S1
S2
RUN ERR
+UZ
X4
X5
24V
GND
-UZ
+ UZ- UZ
X31X20_1X21_1
X20_2X21_2
X15_1
X15_2
S1
S2
RUN ERR
+UZ
X4
X5
24V
GND
-UZ
+ UZ- UZ
[1]
[2]
[3] [3] [3] [3] [3] [3] [3] [3] [3]
[4][5][6]
28215926411
[1]
Line voltage
[4]
MOVIDRIVE
®
system
[2]
Engineering connection
[5]
MOVIDRIVE
®
modular axis system
[3]
EtherCAT
®
/SBus
PLUS
connection
[6]
MOVI-C
®
CONTROLLER
28514688/EN – 02/2019