SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Introduction; MOVI-C CONTROLLER; EtherCAT;SBusPLUS interface; Virtual network card (VNET)

3
Introduction
MOVI-C® CONTROLLER
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
16
Ethernet communication interface (X90)
The Ethernet communication interface(X90) is assigned to the Windows section of the
MOVI‑C
®
 CONTROLLER. The interface is only available if the CFast memory card
with Windows operating system is installed. The following functions can be realized
via this interface:
• Access to the Windows operating system via remote desktop connection
• Connection of a visualization system
• Connection to master level
Ethernet communication interface (X80, X82)
The Ethernet communication interface (X80, X82) is assigned to the control section
(real-time operating system) of the MOVI‑C
®
CONTROLLER. The following functions
can be realized via this interface:
• Engineering of the MOVI‑C
®
CONTROLLER
• PC visualization (e.g. OPC interface)
• Connection to master level
The engineering of the MOVI‑C
®
CONTROLLER comprises the following activities:
• Configuration
• Parameterization
• Programming
Engineering is carried out using the MOVISUITE
®
engineering software. The software
has a number of useful features for startup and diagnostics of all connected
SEW‑EURODRIVE devices.
EtherCAT
®
/SBus
PLUS
interface (X30)
The following devices can be connected to the MOVI‑C
®
CONTROLLER via the
EtherCAT
®
/SBus
PLUS
interface (X30):
• MOVIDRIVE
®
modular application inverter
• MOVIDRIVE
®
system application inverter
• MOVI‑PLC
®
I/O systemC
• Third-party components with ESI project planning file
The maximum number of application inverters that can be connected to the
MOVI-C
®
CONTROLLER is: 32.
Virtual network card (VNET)
The virtual network can only be used if the OMW CFast memory card with Windows
operating system is installed. For further information, refer to the chapters "OMW
CFast memory card"(→217) and "Virtual network card (VNET)"(→223).
28514688/EN – 02/2019