SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Terminal assignment

4
Installation notes
Terminal assignment
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
32
4.5 Terminal assignment
INFORMATION
The assignment "Reserved" means that no cable may be connected to this connec-
tion.
Represent-
ation
Terminal Connection Brief description
GND
24V
X5:24V V
I
24 V DC24V supply voltage
X5:GND GND Reference potentials inside the device
(connected to PE internally)
1
8
X30 Fast system bus SBus
PLUS
based on EtherCAT
®
10/100 BaseT 1000 BaseT 10/100 BaseT 1000 BaseT
1
8
X80/X82:1 TX+ DA+ Transmit line (+) Bidirectional pair A
X80/X82:2 TX- DA- Transmit line (-) Bidirectional pair A
X80/X82:3 RX+ DB+ Receive line (+) Bidirectional pair B
X80/X82:4 Reserved DC+ – Bidirectional pair C
X80/X82:5 Reserved DC- – Bidirectional pair C
X80/X82:6 RX- DB- Receive line (-) Bidirectional pair B
X80/X82:7 Reserved DD+ – Bidirectional pair D
X80/X82:8 Reserved DD- – Bidirectional pair D
10/100 BaseT 1000 BaseT 10/100 BaseT 1000 BaseT
1
8
X90:1 TX+ DA+ Transmit line (+) Bidirectional pair A
X90:2 TX- DA- Transmit line (-) Bidirectional pair A
X90:3 RX+ DB+ Receive line (+) Bidirectional pair B
X90:4 Reserved DC+ – Bidirectional pair C
X90:5 Reserved DC- – Bidirectional pair C
X90:6 RX- DB- Receive line (-) Bidirectional pair B
X90:7 Reserved DD+ – Bidirectional pair D
X90:8 Reserved DD- – Bidirectional pair D
28514688/EN – 02/2019