SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Port overview

10
Technical data
Port overview
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
55
10.3 Port overview
10.3.1 Interface description
The Ethernet interfaces of the MOVI‑C
®
CONTROLLER have the following functions:
• X30 – EtherCAT
®
/SBus
PLUS
interface for master connection
• X80/X82 – Engineering interface for the control section
• X90 – Engineering interface for the Windows section
10.3.2 Engineering interface
Port TCP/
UDP
Function Authorization
21 TCP FTP Reading from and writing to the file system
23 TCP Telnet Reading OEM diagnostic data
310 TCP/
UDP
Data Streaming Reading and writing of all indexed parameters
11740 –
11743
TCP CODESYS engineering Read and write
1740 - 1743 UDP CODESYS engineering Read and write
10.3.3 Windows interface
Depending on the installation and configuration of the Windows operating system and
of additionally installed software components, the following ports are available, among
others:
Port TCP/UDP Function
7 TCP/UDP Echo
9 TCP/UDP Discard
13 TCP/UDP Daytime
17 TCP/UDP Quote of the day
19 TCP/UDP Character generator protocol
135 TCP Microsoft EPMAP (End Point Mapper)/DCE/RPC Locator Service
139 TCP Microsoft EPMAP (End Point Mapper)/DCE/RPC Locator Service
161 UDP SNMP
300 TCP/UDP SMLP
445 TCP Microsoft-DS SMB release (also known as the free implementation Samba)
500 UDP Internet Security Association and Key Management Protocol (ISAKMP)
515 TCP Line Printer Daemon print services
3389 TCP Microsoft Terminal Server (RDP), officially registered as Windows Based Ter-
minal (WBT)
4500 UDP IPSec NAT Traversal (RFC 3947)
5355 UDP LLMNR – Link-Local Multicast Name Resolution
28514688/EN – 02/2019