SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Installation Notes; Electrical installation; Connection to Ethernet network

4
Installation notes
Electrical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
22
No. Designation Terminal Function
[7]
USB interface USB1
USB interfaces for the Windows section
USB interface USB2
USB interface USB3
[8] CFast card slot XM2 Card slot for OMW CFast memory card
(Windows section)
[9] CFast card slot XM1 Card slot for OMH CFast memory card
(Control section)
4.3.3 Voltage supply
An external DC24V power supply unit (power consumption P
max
= 30 W) has to be
used for the voltage supply of the MOVI‑C
®
CONTROLLER.
The maximum permitted length of the DC24V supply cable is 30m.
Wiring diagram
X5
X30
X82
+
-
+24 V
GND
DC 24 V
27744476939
4.3.4 Connection to Ethernet network
To connect the MOVI‑C
®
CONTROLLER to the Ethernet network, connect one of the
Ethernet communication interfaces X80, X82 or X90 (RJ45 plug connector) to the
other network stations using a category 5, class D shielded twisted-pair cable in ac-
cordance with IEC11801 edition2.0.
28514688/EN – 02/2019