SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Connecting USB interfaces; DisplayPort interface connection

4
Installation notes
Electrical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
28
System bus cable
A 4-core system bus cable is used between the MOVI-C
®
CONTROLLER and the
other automation components (such as MOVIDRIVE
®
modular/system application in-
verters). For connecting the EtherCAT
®
/SBus
PLUS
system bus, SEW‑EURODRIVE re-
commends using only prefabricated cables from SEW‑EURODRIVE listed in chapter
"Installation accessories"(→218).
NOTICE
Use of wrong cables
Damage to automation components.
If incorrect cables are used, malfunctions or failures may occur at the connected
devices.
INFORMATION
The mounting plates on which the axis systems are mounted must have a sufficiently
large ground connection, e.g., a ground strap.
Bus termination
Bus termination (for example with bus terminating resistors) is not necessary. The sys-
tem detects automatically if there is no subsequent device connected to a device.
Station address
EtherCAT
®
/SBus
PLUS
devices from SEW‑EURODRIVE do not have an address that
can be set for the device. The devices are detected by their position in the bus struc-
ture and are assigned an address by the EtherCAT
®
/SBus
PLUS
master.
4.3.7 Connecting USB interfaces
The USB interfaces USB1, USB2, and USB3 are assigned to the Windows operating
system (OMW CFast memory card). You can use those USB interfaces to connect a
keyboard, a mouse, or a touchpad for maintenance purposes.
4.3.8 DisplayPort interface connection
The DisplayPort interface assigned to the Windows operating system (OMW CFast
memory card) is used for connecting a monitor to the MOVI‑C
®
CONTROLLER.
28514688/EN – 02/2019