SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Connection between the Windows section and the control section

4
Installation notes
Electrical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
26
Connection between the Windows section and the control section
Connecting via a virtual network card (VNET)
The internal connection between the Windows section and the control section is avail-
able as standard and does not require any additional hardware such as network
cables, for example.
UHX65A
GPOS
(Windows)
RTOS
(Firmware, IEC)
X80
192.168.10.4
X82
10.1.254.128
X90
DHCP
VNET
192.168.2.2
VNET
192.168.2.1
26576023819
Connecting via an external network
A network switch can be used to connect an external network to the Windows section
(X90), the control section (X80, X82) of the MOVI-C
®
CONTROLLER, and another ex-
ternal UHX25A/UHX45A MOVI-C
®
CONTROLLER (terminal: X80). This connection
option also allows you to connect external devices, e.g. a keypad.
UHX25A/
UHX45A
192.168.10.10
X80
DOP
192.168.10.20
Switch
UHX65A
GPOS
(Windows)
RTOS
(Firmware, IEC)
X80
192.168.10.4
X82
10.1.254.128
X90
DHCP
VNET
192.168.2.2
VNET
192.168.2.1
26576035339
28514688/EN – 02/2019