SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Mechanical installation; Minimum clearance and mounting position

4
Installation notes
Mechanical installation
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
19
4.2 Mechanical installation
CAUTION
Risk of injury to persons and damage to property.
Never install defective or damaged MOVI-C
®
CONTROLLERs.
• Before installation, check the device for external damage. Replace any damaged
device.
4.2.1 Minimum clearance and mounting position
MOVI‑C
®
CONTROLLER is installed in the control cabinet. Observe the following for
installation:
• Install the device with the provided carrier plate to the metal bare back of the con-
trol cabinet.
• To ensure unobstructed cooling of the MOVI-C
®
CONTROLLER, leave a minimum
clearance of 100mm above and below the device's housing as well as 20mm to
the right and left. Make sure air circulation in the clearance is not impaired by
cables or other installation equipment. The preferred mounting position is left of
the axis system.
• Ensure unobstructed cooling air supply and make sure that the
MOVI‑C
®
 CONTROLLER is not exposed to the warm exhaust air from other
devices.
• Only install the device vertically. Do not install the devices horizontally, tilted or up-
side down.
28514688/EN – 02/2019