SEW-Eurodrive MOVI-C CONTROLLER UHX65A - Establishing a connection between engineering PC and MOVI-C CONTROLLER

5
Startup
Configuration of the EtherCAT®/SBusPLUS stations
Manual – MOVI‑C
®
CONTROLLER progressiveUHX65A
37
3. Select the Internet protocol version 4 "TCP/IPv4" in the adapter properties.
4. Enter the IP address parameters of the engineering PC in the Internet protocol
properties. Note that the IP address of the engineering PC is different from the IP
address of all other network stations and thus is unique. The network address
(here the first 3 address blocks) for all network stations must be identical and the
station address (here the last address block) of the engineering PC must be differ-
ent from the network address of all other stations.
9007216660423563
ð In this example, the IP address of the engineering PC is: 192.168.10.38
28514688/EN – 02/2019