SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 41

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
41
Bore di-
mension
Value
Y
2
Housing dimension Y − 30 mm (1.2 in), see the following dimension
drawing
3. Mark the tapped holes on the mounting surface [4].
4. Drill the bores at the marked points.
5. Firmly screw the unit on the mounting surface [4] from the back via the through
bores. Use suitable mounting and locking elements, e.g.:
• M6 screws [1]
• Lock washers [2]
• Washers [3]
20278543/EN – 09/2014