SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 40

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
40
– Suitable spacers
– Mounting plate (with an appropriate cut-out for long cooling fins)
• Suitable mounting and safety elements, e.g. M8 screws of an appropriate length
with washers
• Suitable locking devices, e.g. lock washers
X
2
Y
Y
2
X
[1]
[2]
[3]
[4]
18014398973593739
[1] Mounting elements, e.g. M8 screws
[2] Locking elements, e.g. lock washers
[3] Mounting elements, e.g. washers
[4] Mounting surface, e.g. mounting plate
X, Y Housing dimensions
X
2
, Y
2
Bore dimensions
Proceed as follows to mount the unit:
1. Refer to the dimension drawing in chapter “Technical data” for the housing dimen-
sions X and Y.
2. Refer to the following table for dimensions of the bores:
Bore di-
mension
Value
X
2
Housing dimension X − 30 mm (1.2 in), see the following dimension
drawing
20278543/EN – 09/2014