Sharp 60X50H - Turning the TV on;off; Supplying electric power to the antenna

19
Preparation
Turning the TV on/off
Supplying electric power to the
antenna
When you set-up the D-TV antenna for the fi rst time,
or connect the antenna to a community antenna, you
need to proceed to set the antenna by following this
manual.
Selected item Description
On
Select “On” when your antenna is set-up
and connected independently.
Typical supply voltage: 5V
Typical supply current: 50mA
Off
Select “Off” when you do not need to
supply voltage to your antenna, i.e.
when your antenna is connected to a
community antenna. (The factory default
setting of this function is “Off”.)
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Antenna setup-DIGITAL”
and then press
ENTER
.
6
Press
a
/
b
to select “Supply voltage” and
then press
ENTER
.
7
Press
c
/
d
to select “On” and then press
ENTER
.
8
Press
D-TV
to access D-TV mode.
1
Press
b
/
c
/
d
to select “View setting”.
4
Press
a
/
b
to select “Channel settings” and
then press
ENTER
.
5
TEXT
TEXT
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby
mode.
Turning on/off the power
• To turn on the power
Press
POWER
on the TV. (After several seconds, an
image appears with sound.)
NOTE
• Wait more than fi ve seconds until you press
POWER
on
the TV after inserting the power plug.
• To turn off the power
Switch it off by pressing
POWER
on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby
by pressing
POWER
on the remote control.
• Switching on from standby
From standby, press
POWER
on the remote control.
POWER
button
POWER
button
60X50H_en_ID5.indd 1960X50H_en_ID5.indd 19 2011-6-13 17:19:552011-6-13 17:19:55