Sharp 60X50H - Preparation; Attaching the stand unit

9
Preparation
• Before attaching (or detaching) the stand, unplug the AC power cord from the AC power outlet.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over
.
Attaching the stand unit
Confi rm that there are screws with the stand unit.
Four big screws, four middle screws and
two long screws
(Big) (Middle) (Long)
Attach the support angle for the stand unit
onto the base using the big screws with a
screwdriver as shown.
2
1
Support
angle
1
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
2
Insert and tighten middle screws into the holes
on the rear of the TV.
1
1
2
2
Soft cushion
Attaching the support cover.
1
Insert the support cover.
2
Insert and tighten long screws into the hole of
the support cover.
2
1
1
2
3
4
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
60X50H_en_ID5.indd 960X50H_en_ID5.indd 9 2011-6-13 17:19:522011-6-13 17:19:52