Sharp MX-M264N - Page 670

7-35
SYSTEM SETTINGS
Contents
*1 When the hard disk drive is installed.
*2 When the automatic document feeder is installed.
*3 When a paper drawer is installed.
*4 When a finisher is installed.
*5 When plasmacluster ion generator is installed.
Copy Function Settings
● Disabling of Devices 7-70
 Disabling of Document Feeder*
2
Disabled 7-70
 Disabling of Duplex Disabled 7-70
 Disabling of Optional Paper Drawer*
3
Disabled 7-70
 Disabling of Tray Settings Disabled 7-70
 Disabling of Finisher*
4
Disabled 7-70
 Disabling of Offset Disabled 7-70
 Disabling of Stapler*
4
Disabled 7-70
● Fusing Control Settings 16 - 23 lbs. (60 - 89g/m
2
) 7-70
● Plasmacluster Settings*
5
7-71
 Plasmacluster operation when the machine’s power is turned on ON, fan speed: Low 7-71
 Plasmacluster operation when the machine’s power is turned off ON, immediately OFF 7-71
 Status indicator setting Pattern 1 7-71
Item Factory default setting Page
■ Copy Function Settings
7-72
● Initial Status Settings
7-72
 Color Mode Full Color
 Paper Tray Varies depending on the machine
configuration
 Exposure Type Auto
 Copy Ratio 100%
 2-Sided Copy 1-Side to 1-Side
 Output –
● Other Settings 7-73
 Copy Exposure Adjustment 7-73
 Rotation Copy Setting Enabled 7-73
 Add or Change Extra Preset Ratios – 7-73
 Setting a Maximum Number of Copies 999 7-73
 Initial Margin Shift Setting
7-73 Side 1 1/2"
 Side 2 1/2"
Item Factory default setting Page