Sharp MX-M464N - Using the [Binding Change] Key

2-17
COPIER
Contents
Using the [Binding Change] key
4
Check the paper to be used.
Make sure that the desired paper (tray) is selected.
• To change the paper (tray), touch the [Paper Select] key.
+ PAPER TRAYS (page 2-11)
Depending on the size of the placed original, there may be cases where the same size of paper as the original is not
selected automatically. In this event, change the paper size manually.
5
Set the number of copies (number of
sets) with the numeric keys.
• Up to 999 copies (sets) can be set.
• If you are only making a single copy, the copy can be made with the copy number display showing "0".
If an incorrect number of copies is set...
Press the [CLEAR] key ( ) and then enter the correct number.
6
Press the [START] key.
To cancel scanning of the original and copying...
Press the [STOP] key ( ).
Originals Binding Change is used Binding Change is not used
The reverse side
is upside down.
The reverse side
is not upside
down.
Select this when
the pages will be
bound into a
tablet.
Select this when
the pages will be
bound into a
booklet.
Auto
8½x11
Plain
8½x11
Color Mode
Special Modes
2-Sided Copy
Output
File
Quick File
Copy Ratio
100%
Original
Paper Select
Auto
Full Color
Exposure
Auto
Preview
Plain
3.
1.
2.
4.
8½x11
11x17
8½x11R
8½x14
8½x11
Plain
7
8½11
Special Modes
2-Sided Copy
A
12
A
A
A
3
A