Sharp MX-M464N - Part Names and Functions; Exterior

1-3
BEFORE USING THE MACHINE
Contents
This section provides basic information about the machine. Please read this chapter before using the machine.
PART NAMES AND FUNCTIONS
EXTERIOR
(1) Automatic document feeder
This automatically feeds and scans multiple originals. Both
sides of 2-sided originals can be automatically scanned.
+ PLACING THE ORIGINAL (page 1-41)
(2) Keyborad
*
Use this as a substitute for the soft keyboard displayed on
the touch panel. When not being used, it can be stored
under the operation panel.
+ KEYBOARD (page 1-81)
(3) Output tray (center tray)
*
Output is delivered to this tray.
(4) Punch module
*
This is used to punch holes in output. Requires a saddle
stitch finisher, saddle stitch finisher (large stacker), or
finisher (large stacker).
+ PUNCH MODULE (page 1-62)
(5) Saddle stitch finisher (large stacker)
*
This staples and folds paper. A punch module can also
be installed to punch holes in output paper.
+ SADDLE STITCH FINISHER (LARGE STACKER)
(page 1-57)
(6) Tray 1
This holds paper.
+ TRAY SETTINGS FOR TRAY 1 TO 4 (page 1-30)
(7) Tray 2 (when a paper drawer is installed)*
This holds paper.
+ TRAY SETTINGS FOR TRAY 1 TO 4 (page 1-30)
(8) Tray 3 (when a paper drawer is installed)*
This holds paper.
+ TRAY SETTINGS FOR TRAY 1 TO 4 (page 1-30)
(9) Tray 4 (when a paper drawer is installed)*
This holds paper.
+ TRAY SETTINGS FOR TRAY 1 TO 4 (page 1-30)
* Peripheral device.
BEFORE USING THE MACHINE
(7)
(6)
(5)
(4)
(1)
(3)
(2)
(8)
(9)