PREVIEW CHECK SCREEN
This section explains the preview check screen.
(1) Preview image
A preview of the scanned original appears.
If the image is cut off, use the scroll bars at the right and 
bottom of the screen to scroll the image. Touch a bar and slide 
it to scroll. (You can also touch the   keys to scroll.)
(2) Change page keys
When there are multiple pages, use these keys to 
change pages.
•  keys:  Go to the first or the last page.
•  keys:  Go to the previous page or the next 
page.
•
Page number display:
This shows the total number of pages 
and the current page number. You can 
touch the current page number key and 
enter a number with the numeric keys 
to go to that page number.
(3) [Sender Info] key
When Internet fax mode is selected, touch to display the 
sender information for I-fax own address send.
This key can only be touched when the entire preview 
image is displayed in the preview screen.
(4) [Function Rev.] key
Touch to check special mode settings or scan settings for 
two-sided originals.
(5) Display zoom key
Use this to set the zoom ratio of the displayed image. 
Changes from the left in the order "Full Page", "Twice", 
"4 Times", "8 Times". The setting applies to all pages in 
the file, not just the displayed page.
(6) "Display Rotation" key
This rotates the image right or left by 90 degrees. The 
rotation applies to all pages in the file, not just the 
displayed page.
(7) [Start Sending] key
Touch to begin transmission.
• A preview image is an image for display on the touch panel. It will differ from the actual print result.
• The preview image reflects certain scanning and special mode settings.
Settings reflected in the preview image are as follows:
Scanning settings: Original
Special modes: Erase, Dual Page Scan, Card Shot, 2in1, Blank Page Skip