EasyManuals Logo

Sharp MX-M7570 User Manual

Sharp MX-M7570
935 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
1-131
BEFORE USING THE MACHINEâ–ºHOW TO PLACE THE ORIGINAL
AUTOMATIC DOCUMENT FEEDER
This section explains how to place originals in the automatic document feeder.
• Place originals of different sizes together, if needed, in the automatic document feeder. In that case, use the "Others"
function in each mode to set [Mixed Size Original]. An original cannot be detected if all pages are of the same size but
some of them are set in a different orientation.
• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
• If originals have damp spots due to correction fluid, ink or paste up glue, wait until the originals are dry before making
copies. Otherwise the interior of the machine or the document glass may be soiled.
• Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result.
Transparency film or other transparent material for backup copy, tracing paper, carbon paper, thermal paper or originals
printed with thermal transfer ink ribbon should not be fed through the document feeder. Originals to be fed through the
feeder should not be damaged, crumpled, folded, loosely pasted together, or have cut-out holes. Originals with multiple
punched holes other than two-hole or three-hole punched paper may not feed correctly.
• When using originals with two or three holes, place them so that the punched edge is at a position away from the feed slot
of the document feeder tray. Specify the orientation of the original using [Original].
• For a thin original (9 lbs. to 14 lbs. (35 g/m
2
- 49 g/m
2
)), use [Slow Scan Mode] in the "Others". For this type, 2-sided
scanning is disabled.
5-1/2" x 8-1/2" (B5)
8-1/2" x 11" (A4)
Hole positions
Feed slot

Table of Contents

Other manuals for Sharp MX-M7570

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp MX-M7570 and is the answer not in the manual?

Sharp MX-M7570 Specifications

General IconGeneral
Print TechnologyLaser
Print Speed75 ppm
Max Print Resolution1200 x 1200 dpi
Duplex PrintingYes
Max Scan Resolution600 x 600 dpi
Copy Speed75 cpm
Max Copy Resolution600 x 600 dpi
Fax CapabilityOptional
Fax Transmission Speed33.6 kbps
Maximum Paper SizeA3
Network ConnectivityYes
Scanner TypeColor Flatbed Scanner with Duplex Single Pass Feeder (DSPF)
FunctionsPrint, Copy, Scan
Original SizeA3
ConnectivityUSB 2.0, Ethernet
Operating System CompatibilityWindows, Mac

Related product manuals