4-50
FACSIMILE►BASIC TRANSMISSION METHODS
CHANGING THE RESOLUTION
The resolution can be specified to match the characteristics of the original, such as text or photo, the size of the text, and
the darkness of the image.
Resolution settings
Resolution Suggestion
Standard
Select this setting when your original consists of normal-sized text (like the text in this manual).
Fine Select this setting when your original has small text or diagrams with fine lines.
The original will be scanned at twice the resolution of the [Standard] setting.
Super Fine Select this setting when your original has intricate pictures or diagrams.
A higher-quality image will be produced than with the [Fine] setting.
Ultra Fine Select this setting when your original has intricate pictures or diagrams.
This setting gives the best image quality. However, transmission will take longer than with
the other settings.
Half Tone Select this setting when your original is a photograph or has gradations of color (such as a
color original).
This setting will produce a clearer image than [Fine], [Super Fine], or [Ultra Fine] used alone.
Halftone cannot be selected when [Standard] is used.
• When using the automatic document feeder, the resolution setting cannot be changed once scanning has begun.
(However, when "Job Build" or "Preview Setting" in "Others" is used, the resolution can be changed each time a new set of
originals is inserted.)
• When a fax is sent at [Ultra Fine], [Super Fine], or [Fine] resolution, a lower resolution will be used if the receiving machine
does not have that resolution.
• Fax resolution setting
In "Settings (administrator)", select [System Settings] → [Image Send Settings] →[Fax Settings] → [Default Settings] →
[Resolution Setting].
The “Apply the Resolution Set when Stored” function saves the transmission resolution when saving a fax, and then uses
that resolution when resending the fax.
• If the image is distorted
In "Settings (administrator)", select [System Settings] → [Image Send Settings] →[Fax Settings] → [Default Settings] → [ECM].
You can enable ECM (Error Correction Mode) to automatically resend only the part of the image that was distorted.
If the receiving machine is a Super G3 machine, ECM will always operate, regardless of this setting.
1
Tap the [Resolution] key.
2
Tap the key of the desired resolution.
When your original is a photograph or has gradations of
color (such as a color original), and you wish to produce a
clearer image than [Fine], [Super Fine], or [Ultra Fine] used
alone, set the [Half Tone] checkbox to . Halftone cannot
be selected when [Standard] is used.
After the settings are completed, tap .
Original
Fine
Half Tone
(Original with shades of color)
Standard Super Fine Ultra Fine
Preview
CA
Start
To Next Page
Loading...
Need help?
General
